Procom Points List

To correctly set up your Procom unit before sending out, we require that some thought be given to the inputs, zones, outputs and output control devices. Please print off this page and fill in to suit your application. To view some samples visit the link below. If you require any assistance or advice .... contact us .... we're here to help you.

The first table is required to assign the input sensors, type of sensor and any related zone .

Input Number	Sensor name / zone name ( IF single zone forgo zone name )
1
2
3
4
5
6
7
8

Table 2 identifies the output devices that will be controlled. ( The basic Procom unit is provided with 12 outputs ) Note: If note all are used, juts label them as future .... that's right ... say in a couple years you add fog cooling .... well guess what your Procom unit is already to control the fog system. Its just a matter of telling it that output # is now for fog cooling or humidification etc. and you are off to the races.

Output Number	Zone number/name, device name, control action ( ie heating, cooling, fog etc. )
1
2
3
4
5
6
7
8
9
10
11
12

Table three is to be used on larger systems where an expansion module is required. If you have less than 12 points of control, this chart need not be filled in unless you have a lot of future expansions on your mind or would wish a few extra points for irrigation/misting control.

Output Number	Zone number/name, device name, control action ( ie heating, cooling, fog etc. )
13
14
15
16
17
18
19
20
21
22
23
24

 

Show me a sample points sheet

AGROPONIC INDUSTRIES LTD.
908 RANCHVIEW CRES. NW., CALGARY, ALBERTA, CANADA, T3G1P9
ph (403)241-8234, fax (403)241-8234
Email: agropon@agroponic.com, ULR: agroponic.com

< Back to Computer Controls
<Procom Specification sheet