Welcome to our 30' Reinforced Freestanding Greenhouse Detail Page

This page make take some time to load up entirely so be patient. This contains current details and features on our 30 foot wide freestanding units. It has always been our firm belief to provide as much detail as possible for our clients when considering a greenhouse purchase. At lot of companies promise a lot of things ...... but show little. We believe a picture and detail sheets are worth a thousand words.

A word about the images below. These are in approximately 70% scale. If you wish to view the image in full size simply click the image and a full sized view will be provided. To return to this page from viewing a large scale image please use the return function on your web browser.

If you study page one you will find that all of our arches are reinforced / wielded web type design. This provides incredible strength. This type of arch design is far far more stiff and rigid than the flimsy single bow / cross tie and strut type houses. On closer review you will note that our sidewalls which we call reinforced arch uprights are reinforced as well. This allows our structure to handle considerable sidewall snow loads.

Besides being able to carry high snow loads, our design provides a very stiff structure in high wind loads. Unlike single bow / strutted / cross tie type houses our structure shows less movement in wind events. This means greater poly life and grower confidence.

Need to hang some equipment .... well go ahead.

To view the above in full large
scale - click on the image.
Use the return/back function on your
browser to return

Our standard reinforced arch up-right provides 4'-11" vertical sidewall height below sloping to the peak. For those growers that require higher sidewall clearances we offer 7 foot and 10 foot tall reinforced sidewall packages.

These sidewall packages are great:

• For the Retailer that wishes sidewall walk through possibilities.
• Growers that are raising vertical crops.
• Shade houses
• Equipment/ Storage/ Workshops ---- yes our houses can be hard clad.
  Aircraft hangers etc.
  

To view the above in full large
scale - click on the image.
Use the return/back function on your
browser to return

To view the above in full large
scale - click on the image.
Use the return/back function on your
browser to return

To view the above in full large
scale - click on the image.
Use the return/back function on your
browser to return

Single Door End Package

To view the above in full large
scale - click on the image.
Use the return/back function on your
browser to return

Double Door Package

To view the above in full large
scale - click on the image.
Use the return/back function on your
browser to return

Our vent system offers great features.

Our arch pivots are spaced at 6 feet on center and are attached to our incredibly stiff reinforced arch system .... not to some wet noodle single bow arch. So in wind events .... well our vents will handle the loads.

Second ... Our arch pivot ... which a lot of our clients call shepherds hooks .... are just that. Our reinforced arch design allows the pivot point of our arch pivots to be located at the bottom cord of the arch far far far away from the poly. NO MORE HOLES AT THE PIVOT POINTS is the result. Again longer poly life.

Third ... Our standard vent package on the 30 foot freestanding units are: 1" galvanized schd. 40 drive shaft, racks/pinions and hangers at 6 feet on center ( along each reinforced arch set ). Rubber EDPM flashing seal along the length of the vent. Just to name a few.

To view the above in full large
scale - click on the image.
Use the return/back function on your
browser to return

As indicated below, the double poly roof system allows you to open the roof along the length of the building. How high ??? Well four feet max. Couple that with a Vent Motor and controls such as a Ventstat, Ventmate, Growcom or Procom controller and you will have a true 8 stage vent system. Tons of power and flexibility. It puts you in the drivers seat.

To view the above in full large
scale - click on the image.
Use the return/back function on your
browser to return

Our aluminum base plate system. Once you use our base plate system you will be scratching your head why for all those past years, and poly loss why you put up with the old wood base plate and wire lock set up. Our base is a structure product. It simply attaches to each arch set with clamps provided and is complete with built-in wire lock track. Easy to install ...... looks great ..... won't rot ( like wood ) ..... extend the life of your poly .... and best of all sleep well during those wind events.

To view the above in full large
scale - click on the image.
Use the return/back function on your
browser to return

<back to freestanding main page

< to special package pricing